Electromagnetic Resistive Drift Instability in Current Carrying Low Temperature Tokamak Edges

It is shown that the purely growing electrostatic rippling mode can couple with the shear Alfven wave to give rise to an oscillatory electromagnetic instability in tokamak edge regions. This mechanism can be one of the causes of electromagnetic fluctuations observed near plasma edges. This instability can occur only in the very low temperature regions where resistivity fluctuations can become important due to large electron-ion collision frequency.     

Linear interpolation in a fuzzy information space

An approach to solving a linear interpolation problem in a fuzzy information space is proposed. Two different schemes of interpolation are outlined: a heuristic one, based on the geometrical interpretation of operations, and an optimization one, based on the expansion principle. The results obtained allow performing fuzzy linear prediction. __________ Translated from Kibernetika i Sistemnyi Analiz, No. 2, pp. 55–68, March–April 2006.     

偏振模色散统计特性的研究

利用动态方程研究了偏振模色散矢量的统计特性 ,分别用统计系综和频率系综两种方法进行数值模拟。数值结果表明 ,统计系综和频率系综两种方法的结果一致。在大归一化距离条件下 ,均方根时延的平方随归一化距离线性变化 ;偏振模色散矢量的各个分量服从高斯分布 ,差分群时延服从麦克斯韦分布 ;偏振模色散矢量弥散于整个邦加球     

多功能半导体激光医疗仪电源的研制

根据“多功能半导体激光医疗仪”整机的要求,采用同一电源对667nm和808nm半导体激光器实施供电。为避免电源在开、关机时对半导体激光管产生浪涌冲击,电源在设计中采用了适当的逻辑功能。并可保证对667nm激光器供电时,即使打开808nm激光器供电开关,也不对808nm半导体激光器供电,反之亦然。电源设有手动、计算机两种控制方法,及恒定功率、电流两种工作方式。     

Transient Green’s Tensor for a Layered Solid Half-Space With Different Interface Conditions

Pulsed ultrasonic techniques can be and have been used to examine the interface conditions of a bonded structure. To provide a theoretical basis for such testing techniques we model the structure as a layer on top of a half-space, both of different elastic properties, with various interface bonding conditions. The exact dynamic Green’s tensor for such a structure is explicitly derived from the three-dimensional equations of motion. The final solution is a series. Each term of the series corresponds to a successive arrival of a “generalized ray” and each is a definite line integral along a fixed path which can be easily computed numerically. Willis’ method is used in the derivation. A new scheme of automatic generation of the arrivals and ray paths using combinatorial analysis, along with the summation of the corresponding products of reflection coefficients is presented. A FORTRAN code is developed for computation of the Green’s tensor when both the source and the detector are located on the top surface. The Green’s tensor is then used to simulate displacements due to pulsed ultrasonic point sources of known time waveform. Results show that the interface bonding conditions have a great influence on the transient displacements. For example, when the interface bonding conditions vary, some of the first few head waves and regular reflected rays change polarities and amplitudes. This phenomenon can be used to infer the quality of the interface bond of materials in ultrasonic nondestructive evaluation. In addition the results are useful in the study of acoustic microscopy probes, coatings, and geo-exploration.     

动态光散射法研究海藻酸钠凝胶松弛行为

在前文的基础上，用相关函数轮廓分析的方法剖析了运动模型模式的复杂性。通过海藻酸钠水溶液在０．１ｍｏｌ／ＬＣａＣｌ２水溶液透析凝胶化过程中交联网络的松弛时间谱表明它不是单一的峰，有两上特征运动模式，并随透析向更慢的运动模式发展，这很慢的运动模式估计与区域的结构的生成有关。     

分散网络制造浅谈

网络社会的制造业将是一个全球化的分散型的制造体系.分散网络制造是基于互联网的制造活动,因此,它具开放的、虚拟的,以及资源和技术更合理配置的特点.其组织模式是多种多样的,按现今国防工业现状,宜采用项目领导小组统一协调和控制下的分阶段动态联盟更为合适.为此,分析了网络无序化、企业属性知识不足、利益分配不易等问题带来的困难,并提出了一些建议.     

回旋管的应用研究

文章论述了推广回旋管应用中所碰到的高功率传输,模式变换和辐射尖锐的波束等技术难点,对现有的准光系统提出了改进措施。     

弱激发氩离子激光的振荡频率特性

通过改变激光器的相对激发,观察到了氩离子激光器振荡频率的演变特性。用模竞争效应对实验现象进行了理论解释。     

单模光纤的传输衰减随温度变化的研究

本文从实验上测量了单模石英光纤在－50～120℃范围内的损耗。随着温度升高，光纤的损耗随之降低，在常温附近达到最小。其后损耗随着温度的继续升高而增加。损耗的变化主要是由于杂质的吸收和微弯损耗。本文对杂质的吸收以及微弯损耗进行了数值模拟，并且从理论上定性地解释了损耗对温度的依赖关系。